Some common reasons that easily cause the printer to burn the print head
Source:
|
Author:hkwf93a9a
|
Published time: 2020-04-14
|
2657 Views
|
Share:
The printer often encounters various unexpected glitches. For many people, the most troublesome one is burning the nozzle. As the core part of the photo machine, the print head is very expensive. Once burned, it will inevitably increase the production cost. Secondly, the burnout of the print head will also slow down the printing progress of the order and affect the work efficiency.
This article summarizes some of the reasons that are easy to cause the printer to burn the print head. You can briefly understand it and evade it according to the basis.
1. Ground wire. The main purpose of the grounding wire is to prevent the accumulation of static electricity in the machine itself. Once excessive static electricity is difficult to discharge from the body, it will cause problems such as burning print head and board.
2. Voltage and current overload. This kind of situation occurs in the peak period of electricity consumption, especially in summer, please be sure to install a 5000W voltage regulator to prevent it from happening.
3. Switch on and off frequently. The current at the moment of start-up has an impact on the machine itself. Frequent switching on and off will only increase the burden on the print head and even burn it. The recommended interval is five minutes.
4. Print in low ink state. During the printing process, the ink is used up. If you do not add ink in time, the print head will be burned out for a long time, and the print head will burn out, so you need to add ink in time if you find that the ink is insufficient!
5. High temperature. The main performance is: long time overload operation or room temperature is too high, it is recommended to print in the state of ambient temperature 15 ℃ ~ 30 ℃, humidity 35% ~ 65%.
6. The board has ink. The ink used in the printer has a certain degree of corrosivity. Dropping on the board will not only cause corrosion, but also cause problems such as short circuit and burn-in problems.
